Installing AQUAGUARD®

AQUAGUARD 5000 InstallationUtilizing a special application process, AQUAGUARD is spray applied in a single coat process or a roll on application to both old and new pools, spas and fountains. This method of application provides a thick continuous finish that bonds to an existing pool surface in excess of 3000 psi and creates a finish that is uniform in texture, color, and appearance. Fine fiberglass reinforcing cloth leaves unsightly seams, ragged edges and fibrous textures. AQUAGUARD eliminates these unsightly problems.

AQUAGUARD can be easily installed in a pool in just a few short days. First, the pool is properly drained and existing surface is repaired and renovated. Using a heavy-duty sealer, coating is applied to recondition and seal the pool surface. Then the final top coat is spray or roll applied forming a thick continuous barrier that seals your pool against the elements which can destroy traditional pool finishes. The result is a beautiful protective finish, rich in color and texture virtually impervious to chemical attack and physical wear.

AQUAGUARD not only restores everlasting beauty to your pool, it makes your pool easier to maintain and clean. Since AQUAGUARD is non-porous, algae cannot penetrate the surface and most water or chemical stains can be easily removed. This means less maintenance, less chemical usage, and less time and money cleaning your pool.

Site Developed by EPSIT.net, a division of LivingToday.tv.   Copyright © 2008 Aquatic Surfaces   All Rights Reserved.